Aastra Telecom AastraLink Pro 160 - Manual (Page 52)

Managing IP Phone Users
3-8 41-001190-02 Rev. 01, Rel. 1.2
AastraLink Pro 160 Administrator Guide
• Outgoing Line
Specifies which outgoing line this IP phone uses for outgoing calls. The term
“outgoing line” refers to one of the 6 FXO ports that are located on the back
of the AastraLink device.
The default is Any. Alternatively, you can specify that this phone may only
use a specific outgoing line for its calls. This is useful if different FXO lines
have different originating CLID, and is usually used in combination with the
Configuration->Dialplan->FXO Lines feature so that incoming and
outgoing calls are routed using the same FXO line.
• Phone Type
Specifies the model of this Aastra IP phone. Select the applicable phone from
the list. After saving the User information page and then redisplaying the User
information page to edit, this field becomes read-only.
• Phone Firmware Version (display only, not editable)
Displays the current phone’s (User or Administrator) firmware version
currently installed and being used on the phone.
IP Address (display only, not editable)
Displays the current IP Address assigned to this phone (User or
Administrator) used when the phone last registered to the AastraLink.
• MAC Address (not applicable when adding/editing a 420d handset)
Specifies the MAC Address assigned to this IP phone. When adding or editing
a phone in the AastraLink network, you must enter the applicable MAC
address of the phone in this field. Not used for 420d handsets. Refer to the
next bullet “Mobility Base Unit” for more information.
• Mobility Base Unit (applicable to the MBU 420d handsets only)
Specifies the 420d handset and MBU number for which you want to apply the
current phone
information. This drop-down list shows the available handsets
(max 8 per MBU) for all currently provisioned MBU-400 units, and is used
instead the of MAC address field for 420d phone model.