Aastra Telecom AastraLink Pro 160 - Manual (Page 305)

Reinstalling System Software Using Recovery Mode
41-001190-02 Rev. 01, Rel. 1.2 7-17
Troubleshooting Solutions
Reprogramming the CompactFlash Card
If the CompactFlash (CF) card is defective, and a replacement card needs to be
programmed with a factory fresh image, you can use the Recovery Mode UI to set
the AastraLink Pro 160 CompactFlash card back to its original settings
You should only reprogram the CompactFlash card if the AastraLink Pro 160 is
continually entering recovery mode and will not correct itself, even after several
reboot attempts.
Notes: Before starting the reprogramming procedure, note the following important
information:
— When you reprogram the CompactFlash card, all configuration and
voicemail data stored on the card is erased.
— Before you can reprogram the CompactFlash card, you must download
the vnx.dra file from the Aastra support web site, and store the file on a
TFTP, FTP, or HTTP server that is accessible to the AastraLink Pro 160
using its LAN connection.
Use the following procedure to reprogram the Compact Flash Card.
Note: You can contact Technical Support at any time, if necessary, by clicking on
the “Contact Support” link at the bottom right side of the Recovery Mode
UI screen.
AastraLink Recovery UI
Step Action
1 Confirm that the AastraLink is in recovery mode.
The LED should alternate Green/Red/Off to indicate that the device is in recovery mode.