Aastra Telecom AastraLink Pro 160 - Manual (Page 167)

Configuring Dial Plan Settings
41-001190-02 Rev. 01, Rel. 1.2 4-57
Configuring AastraLink Pro 160 System and Network Parameters
Configuring FXO Lines
On the AastraLink Pro, you can configure individual FXO lines (up to 6 lines) for
which incoming calls are routed. The following table identifies the destinations
for which you can choose to route your incoming calls on each line.
You can also specify the number of rings you want the destination phone to ring
before your phone transfers the incoming call.
Note: This feature also allows you to provision FXO lines regardless of the line
state (i.e. even if there is no FXO line voltage) to enable for FXO loopback
door entry phone use.
FXO Line Destinations Description
Default Sends incoming calls according to the configured incoming
call route on the Auto-Attendant page.
SLA (Shared Line
Appearance) Sends the incoming call to the Shared Line Appearance (SLA)
line shared by all users in a Ring Group.
Operator Sends the incoming call to the Operator.
FXS A Sends the incoming call to the FXO Port A.
FXS B Sends the incoming call to the FXO Port B.
<extension number>
<phone number> Sends the incoming call to the specified extension or phone
number.