Aastra Telecom AastraLink Pro 160 - Manual (Page 295)

Restoring AastraLink Factory Default Settings
41-001190-02 Rev. 01, Rel. 1.2 7-7
Troubleshooting Solutions
Restoring AastraLink Factory Default Settings
What Happens if I Restore Factory Default Settings?
If you restore factory default settings on the AastraLink Pro 160, it reverts the
device to its out-of-the-box state — just as it was shipped from the factory. Before
you perform the instructions in this section, note that all configuration
information, voicemail, and other files stored on the AastraLink’s CompactFlash
card are erased as a result of this process.
In addition, after you restore AastraLink factory default settings, you need to once
again perform the initial startup sequence - that is, you need to register an
Administrator phone with the device, and specify several start-up parameters - in
order for the device to begin handling calls on your network.
Using the Reset Switch to Restore Factory Default Settings
Use the following procedure to restore factory default settings on the
AastraLink Pro 160.
Factory Default Restoration Procedure
Step Action
1 Locate the reset switch on the back of the device.
The reset switch is located on the back of the AastraLink Pro 160 (next to the power receptacle).
Back Panel
12 VDC 1.25A A B LAN WAN
/ FAX
TM8DC
/ FAX
1 2 3 4 5 6
LINE
Reset Switch