Aastra Telecom AastraLink Pro 160 - Manual (Page 341)

Remote Office Configuration of the AastraLink Pro 160
41-001190-02 Rev. 01, Rel. 1.2 B-7
Remote Office Configuration of the AastraLink Pro 160 (Server-Side)
2. Phone Configuration
If you create an account on the server for the phone in the same subnet as the
server, the configuration automatically downloads to the phone.
If you create the phone's account on the server using the Web UI to add phones,
the remote phone does not have the configuration required to initiate
communication with the server. Users must enter the server's external gateway IP
and HTTP port from the phone's TUI prompt upon remote installation.
3. Remote Phone Installation
Pre-stage phone
Press <Remote> when the Auto-Discovery screen is presented in TUI.
Non Pre-stage phone
Press <Remote> and enter the external gateway IP (e.g. 65.215.35.80) and HTTP
port start (e.g. 51510) when TUI prompts.
Note: For routers with half-cone NAT, or routers that don’t allow separate port
forwarding, use the value of 9600 instead of 51510.
Upon a successful dialogue with the server and with the pre-configuration or
downloaded configuration, the phone automatically initiates port mapping setups
with Home Router using UPnP.