Enable switch port flow – Allied Telesis AT-S63 User Manual
Page 112
Chapter 6: Port Parameter Commands
112
Section I: Basic Operations
ENABLE SWITCH PORT FLOW
Syntax
enable switch port=
port
flow=pause
Parameter
port
Specifies the port where you want to activate flow
control. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22).
Description
This command activates flow control on a port. Flow control only applies to
ports operating in full duplex mode. When flow control is activated, a port
sends out a PAUSE packet whenever it wants the end node to stop
sending packets.
Example
The following command activates flow control on port 5:
enable switch port=5 flow=pause
Equivalent Command
set switch port=
port
flowcontrol=enable
For information, see “SET SWITCH PORT” on page 115.