Enable log output – Allied Telesis AT-S63 User Manual
Page 234
Advertising
Chapter 14: Event Log and Syslog Client Commands
234
Section II: Advanced Operations
ENABLE LOG OUTPUT
Syntax
enable log output[=
output-id
]
Parameters
output
Specifies the output definition ID number to enable.
The range is 2 to 20.
Description
This command enables an output definition that was disabled using
“DISABLE LOG OUTPUT” on page 232.
Example
The following command enables output definition number 4:
enable log output=4
The following command enables all output definitions:
enable log output
Advertising