Allied Telesis AT-S63 - Manual (Page 582)

Chapter 32: Internet Protocol Version 4 Packet Routing Commands
582 Section VII: Internet Protocol Routing
SHOW IP ROUTE
Syntax
show ip route [general] [fdb] [full]
Parameters
general Displays general routing information, such as the total
number of routes in the cache and the cache size.
fdb Displays the status of the static and dynamic routes.
full Displays both the routes and the general routing
information.
Description
Entering this command without any parameters displays all of the IPv4
interface, static and RIP routes. An example of the information displayed
by this command without the parameters is shown in Figure 52.
Figure 52. SHOW IP ROUTE Command
The columns are described here:
ˆ Destination - Destination IP address of the network or subnet. The
default route is 0.0.0.0.
ˆ Mask - Subnet mask of the destination IP address.
ˆ Protocol - Source of the route. Possible options are:
– Interface - Route was learned by a routing interface.
– Static - Route was entered manually as a static route.
– RIP - Route was learned by RIP.
IP Routes
---------------------------------------------------------
Destination
Mask NextHop Interface
Protocol RipMetric Preference
---------------------------------------------------------
0.0.0.0
0.0.0.0 202.24.124.2 VLAN2-0
Static 1 60
149.102.34.0 255.255.255.0 149.211.54.6 VLAN14-0
Interface 1 1
149.102.37.0 255.255.255.0 149.211.54.6 VLAN14-0
Interface 1 1