Allied Telesis AT-S63 - Manual (Page 127)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 127
SHOW SWITCH PORT
Syntax
show switch port[= port ]
Parameter
port Specifies the port whose parameter settings you want
to view. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22). All ports are displayed if you
omit the port number.
Description
This command displays a port’s current operating specifications, such as
speed and duplex mode. The command displays the following port
information. (For an example of the information displayed by this
command, see Figure 7 on page 131.)
ˆ Port Description - Displays the name of the port. The default name is
“Port_” followed by the port number. To configure a port’s name, refer
to “SET SWITCH PORT” on page 115.
ˆ Port Type - Displays the IEEE standard of a port. For example, the port
type for a twisted pair port on an AT-9424T/SP switch is 10/100/
1000Base-T.
ˆ Status - Displays whether the port is currently enabled or disabled.
When disabled, a port does not forward network traffic. The default is
enabled. To disable or enable a port, refer to “DISABLE SWITCH
PORT” on page 108, “ENABLE SWITCH PORT” on page 111, or “SET
SWITCH PORT” on page 115.
ˆ Link State - Displays the current link state between the port and the
end node. If the port has established a link with an end node, link state
will be “Up.” If there is no link, link state will be “Down.”
ˆ Configured Speed/Duplex - Displays the current configured settings for
speed and duplex mode on the port. The setting of “Auto” indicates the
port has been set to Auto-Negotiation, the default setting. To adjust a
port’s speed and duplex mode, refer to “SET SWITCH PORT” on
page 115.
ˆ Configured MDI Crossover - Displays the current configured setting for
MDI/MDIX on the port. If the port is set to Auto-Negotiation, this field
displays N/A, because the MDI/MDIX setting is set automatically on
the port. A value only appears in this field if you disable Auto-
Negotiation on a twisted pair port and set MDI/MDIX manually. This