Allied Telesis AT-S63 - Manual (Page 576)

Chapter 32: Internet Protocol Version 4 Packet Routing Commands
576 Section VII: Internet Protocol Routing
SHOW IP INTERFACE
Syntax
show ip interface[= interface |eth0]
Parameters
interface Specifies the interface name. An interface name
consists of “VLAN” followed by the name or ID (VID)
of the VLAN and the interface number (e.g., vlan-
Sales-0 or vlan4-0). If no interface value is specified,
the switch displays all the interfaces.
The “eth0” value can be used to designate the local
interface.
Description
This command displays the routing interfaces on a switch. An example of
the information displayed by this command is shown in Figure 49.
Figure 49. SHOW IP INTERFACE Command
The local interface of a switch, if one has been designated, is listed twice
in the table, as “eth0” at the top of the table and again as a regular entry.
For instance, the local interface on the switch in the above example is the
VLAN8-1 interface because its values and those of the “eth0” interface are
identical. The “eth0” entry contains null values (i.e., 0.0.0.0) if no local
interface is designated on the unit.
The columns in the display are:
ˆ Interface - The interface name consisting of the VLAN’s identification
(VID) and interface number. A hash symbol (#) marks IP interfaces
where there are no active nodes in the VLAN on the switch.
ˆ IPAddress - The interface’s IP address. The address is assigned
manually to the interface or automatically by a DHCP or BOOTP
server. If the address is 0.0.0.0, the interface is configured to receive
---------------------------------------------------
Interface
IPAddress NetMask RipMet
---------------------------------------------------
eth0
149.55.14.8 255.255.255.0 1
vlan2-0 149.123.11.21 255.255.255.0 1
vlan5-0# 149.55.12.15 255.255.255.0 2
vlan8-0 149.55.13.2 255.255.255.0 1
vlan8-1 149.55.14.8 255.255.255.0 1