Show asyn – Allied Telesis AT-S63 User Manual
Page 55
AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations
55
SHOW ASYN
Syntax
show asyn
Parameters
None.
Description
This command displays the settings for the serial terminal port on the
switch, used for local management of the device. An example of the
display is shown in Figure 1.
Figure 1. SHOW ASYN Command
To configure the serial port’s baud rate, refer to “SET ASYN” on page 48.
To configure the command line prompt, refer to “SET PROMPT” on
page 36. You cannot adjust the parity, data bits, or stop bit of the serial
terminal port.
Example
The following command displays the serial terminal port settings:
show asyn
Asynchronous Port (Console) Information:
Baud Rate ................................. 115200
Parity .................................... NONE
Data bits ................................. 8
Stop bits ................................. 1
Prompt .................................... "Sales Switch"