Allied Telesis AT-S63 - Manual (Page 129)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 129
ˆ Unknown Multicast Egress Filtering - Displays the status of unknown
egress multicast filtering. If enabled, the port discards all unknown
egress multicast packets. The default is disabled. To configure this
parameter, refer to “SET SWITCH PORT FILTERING” on page 119.
ˆ Unknown Unicast Ingress Filtering - Displays the status of unknown
ingress unicast filtering. If enabled, the port discards all unknown
ingress unicast packets. The default is disabled. To configure this
parameter, refer to “SET SWITCH PORT FILTERING” on page 119.
ˆ Unknown Unicast Egress Filtering - Displays the status of unknown
egress unicast filtering. If enabled, the port discards all unknown
egress unicast packets. The default is disabled. To configure this
parameter, refer to “SET SWITCH PORT FILTERING” on page 119.
ˆ Broadcast Rate Limiting Status and Broadcast Rate - Displays the
status of the broadcast rate limiting feature. If enabled, the port limits
the number of ingress broadcast packets per second to the rate
specified. Ingress broadcast packets that exceed the threshold are
discarded by the port. The default setting for this feature is disabled.
The default rate is 262,143 packets per second. To set this feature,
refer to “SET SWITCH PORT RATELIMITING” on page 122.
ˆ Multicast Rate Limiting Status and Multicast Rate - Displays the status
of the multicast rate limiting feature. If enabled, the port limits the
number of ingress multicast packets per second to the rate specified.
Ingress multicast packets that exceed the threshold are discarded by
the port. The default setting for this feature is disabled. The default rate
is 262,143 packets per second. To set this feature, refer to “SET
SWITCH PORT RATELIMITING” on page 122.
ˆ Unknown Unicast Rate Limiting Status and Unknown Unicast Rate -
Displays the status of the unicast rate limiting feature. If enabled, the
port limits the number of unknown ingress unicast packets per second
to the rate specified. Unknown ingress unicast packets that exceed the
threshold are discarded by the port. The default setting for this feature
is disabled. The default rate is 262,143 packets per second. To set this
feature, refer to “SET SWITCH PORT RATELIMITING” on page 122.
ˆ PVID - Displays the port’s VLAN ID number. This number is equivalent
to the VID of the VLAN where the port is currently an untagged
member. The default is 1, the VID of the Default_VLAN. To add a port
to an existing VLAN or to create a new VLAN, refer to “ADD VLAN” on
page 492 and “CREATE VLAN” on page 495.
ˆ Port Priority - Displays the Class of Service priority assigned to the
port. This priority level applies to all ingress untagged packets received
on the port. The default setting is 0. At the default setting, all ingress
untagged packets received on the port are stored in the egress port’s
Q1 egress queue. To set this parameter, refer to “SET SWITCH PORT
PRIORITY OVERRIDEPRIORITY” on page 280. To adjust the
mappings of priority levels to egress queues, see “SET QOS COSP”
on page 277.