Allied Telesis AT-S63 - Manual (Page 147)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 147
SHOW SWITCH FDB
Syntax
show switch fdb [macaddress|destaddress= macaddress ]
[port= port ] [type|status=static|staticunicast|
staticmulticast|dynamic|dynamicunicast|dynamicmulticast]
[vlan=
name ]
Parameters
address Specifies a MAC address. Use this parameter to determine
the port on the switch on which a particular MAC address
was learned (dynamic) or assigned (static). The address can
be entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
port Specifies a port on the switch. Use this parameter to view all
addresses learned on a particular port. You can specify more
than one port.
type or Displays specific types of MAC addresses. Options are:
status
static Displays all static unicast and multicast
MAC addresses.
staticunicast Displays all static unicast addresses.
staticmulticast Displays all static multicast addresses.
dynamic Displays all dynamic unicast and
multicast MAC addresses.
dynamicunicast Displays all dynamic unicast addresses.
dynamicmulticast Displays all dynamic multicast
addresses.
vlan Specifies a VLAN name. Use this parameter to view the MAC
addresses learned or assigned to the ports of a particular
VLAN on the switch.
Note
You can specify more than one parameter at a time with this
command.