Allied Telesis AT-S63 - Manual (Page 626)

Chapter 36: 802.1x Port-based Network Access Control Commands
626 Section VIII: Port Security
ENABLE PORTACCESS|PORTAUTH
Syntax
enable portaccess|portauth
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
None.
Description
This command activates 802.1x Port-based Network Access Control on
the switch. The default setting for this feature is disabled.
Note
You should activate and configure the RADIUS client software on
the switch before activating port-based access control. Refer to
“SET AUTHENTICATION” on page 705.
Example
The following command activates 802.1x Port-based Network Access
Control on the switch:
enable portaccess