Allied Telesis AT-S63 - Manual (Page 558)

Chapter 32: Internet Protocol Version 4 Packet Routing Commands
558 Section VII: Internet Protocol Routing
DELETE IP ROUTE
Syntax
delete ip route= ipaddress [interface= interface ]
nexthop= ipaddress mask= subnetmask
Parameters
route Specifies the destination IP address of the static,
dynamic, or default route to be deleted. The IP
address for the default route is 0.0.0.0.
interface Specifies the name of the interface where the static or
dynamic route is assigned. An interface name
consists of “VLAN” followed by the name or ID (VID)
of the VLAN and the interface number (e.g., vlan-
Sales-0 or vlan4-0). This parameter is optional.
nexthop Specifies the IP address of the next hop of the route.
The next hop is required when deleting a static or
dynamic route, but not when deleting a default route.
mask Specifies the subnet mask for the destination IP
address. The mask for the default route is
255.255.255.255.
Description
This command deletes static, dynamic, and default routes from the routing
table. To display the existing routes, refer to “SHOW IP ROUTE” on
page 582.
Examples
This command deletes the static route to the remote subnet 149.124.55.0
with the subnet mask 255.255.255.0 and the next hop 149.124.22.12
delete ip route=149.124.55.0 mask=255.255.255.0
nexthop=149.124.22.12
This command deletes the default route:
delete ip route=0.0.0.0 mask=255.255.255.255