Allied Telesis AT-S63 - Manual (Page 593)

AT-S63 Management Software Command Line Interface User’s Guide
Section VII: Internet Protocol Routing 593
SHOW BOOTP RELAY
Syntax
show bootp relay
Parameters
None.
Description
This command displays the status of the BOOTP relay agent, the IP
addresses of the servers, and packet statistics. An example of the display
is shown in Figure 55.
Figure 55. SHOW BOOTP RELAY Command
The fields in the display are:
ˆ Status: The agent’s status of disabled, the default, or enabled. The
routing interfaces do not forward BOOTP requests when the status of
the BOOTP relay agent is disabled, and do when the status is enabled.
The status is set with “DISABLE BOOTP RELAY” on page 590 and
“ENABLE BOOTP RELAY” on page 591.
ˆ Maximum hops: Maximum value allowed for the hops field in a BOOTP
message before the message is discarded. The default is 4 hops. This
value cannot be changed.
ˆ BOOTP Relay Destinations: The IP addresses of the DHCP or BOOTP
servers, set with “ADD BOOTP RELAY” on page 588.
BOOTP Relaying Agent Configuration
-----------------------------------------------------
Status ............... Disabled
Maximum hops ......... 4
BOOTP Relay Destinations
-----------------------------------------------------
149.55.78.2
149.55.72.12
----------------------------------------------------
BOOTP Counters
InPackets .......... 0 OutPackets .......... 0
InRejects .......... 0
InRequests ......... 0
InReplies .......... 0