Myron L 9PTK - Manual (Page 52)

48
For computers with Bluetooth capability/Bluetooth dongle installed:
First time use of the bluDock:
1. Press any parameter button to turn the Ultrameter III on.
2. Put the Ultrameter III in “Pc On” mode by pressing the
key until “Pc OFF” appears (see Figure 30).
3. Then press the key. “Pc On” will be displayed (see
Figure 31).
nOte: “Pc ini” may momentarily be displayed while initializing (see
Figure 32).
4. Add bluDock to your Bluetooth devices per your operating
system procedure. the blUDOcK Device PassKey is 1234.
5. After pairing, note the number of the COM port assigned by
the computer. In Windows XP, note the number of the outgoing
COM port assigned by the computer.
nOte: The unit will automatically power down after 60 sec. If the unit
powers down during pairing, repeat steps 1-3 above and continue.
C. Memory Stack Download
1. With the Ultrameter III in “Pc On” mode, open the U2CI