Set port mirror fabric_mode2, Set port mirror fabric_mode2 -8, Command mode – Avaya Cajun P550R User Manual
Page 411: Description, Syntax
Chapter 21
21-8
Command Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1
set port mirror Fabric_mode2
Command Mode
Configuration
Description
Set up or remove a port mirror on a switch in Fabric mode 2.
Syntax
To Enable:
set port mirror Fabric_mode2 source-port <mod-port-
range> mirror-port <mod-port-spec> channel <channel>
direction {tx | rx | both | sa | da } sampling {always | disable
| periodic} [sa <MAC-address>] [da <MAC-address>] [max-
packets-sec <max-packets-sec-value>]
To Disable:
clear port mirror Fabric_mode2 channel <channel>
Table 21-5. Parameters, Keywords, Arguments
Parameter
Definition
<mod-port-
range>
Either the single port or the range of ports that you want
to mirror. See Table 21-6 for the specific port ranges that
you can mirror.
<mod-port-spec>
The port to which you want to mirror traffic.
Both the source port and mirror port must either:
• Be on the same vlan and have the same vlan
binding
or
• Have vlan binding set to bind to all
Note:
Avaya recommends that you mirror traffic to a
port of the same speed or faster than the source
port.
<channel>
The mirror channel that you want to use. Four channels
are available. Enter a number from 1 to 4.
1 of 2