RADWAG MYA 5.3Y.F1 Microbalance - Manual (Page 129)

- 129 -
27.7. Reports from density
Reports from density contain data on carried out density determination
processes of solids, liquids and air. Each report can be previewed, searched by
name, date, code or exported and printed.
Procedure
•
Enter submenu < Databases>, and press < Reports from density>
key
•
Press field of a desired report record, unless it is visible on the top of the
list, wind the list forward using navigating keys
•
Report’s name consists of date and time of its creation, e.g.:
2011.12.12 11:12:15
Caution:
It is possible to use an option for searching a report on density.
List of parameters in a report on density:
1. Sample number, field with a value if in Density mode option: Request
sample number is set = YES
2. Start date
3. End date
4. Density [calculated density of a sample of solid, liquid or
air]
5. Volume [calculated volume of tested sample, density
measurement of solid object]
6. Procedure [depending on selected procedure, data contained
in a report may change]
7. User [name of a user carrying out the procedure]
8. Product [name of tested sample]
9. Standard liquid [name of liquid used for determining density
measurement of solid object]
10. Standard liquid density [density determination of solid object]
11. Temperature [temperature of liquid used for carrying out a
measurement, density determination of solid
object]
12. Plunger volume [density determination of liquid]
13. Mass of steel standard [density determination of air]
14. Mass of aluminium standard [density determination of air]
15. Density of steel standard [density determination of air]
16. Density of aluminium standard [density determination of air]
17. Weighing 1 [mass measurement of tested sample or a
plunger in the air, or mass of measured steel
standard]
18. Weighing 2 [mass measurement of tested sample or a
plunger in liquid, or mass of measured aluminium
standard]