Barco CLM R10+ - Manual (Page 175)

16. Servicing
A
B
C
Image 16-2
Front filter replacement
C AUTION : Never install a used HEPA filter. Always install a new HEPA filter.
C
AUTION
:
Never use the projector with a removed cover. Always reinstall the removed cover.
16.3 Lens installation
How to install the lens
1. Remove the front cover of the projector. See "Removal of the front cover", page 181.
2. Remove the foam rubber in the opening of the lens holder if not yet removed.
3. Place the lock handle A is in its right position (table mounted projector). (image 16-3)
4. Insert the lens in such a way that the female jack (C) is in front of the male jack (upper left corner) (B) and ensure the lens touches
the front plate of the lens holder.
Caution:
Do not release the lens yet, as the lens may fall out of the lens holder.
5. Secure the lens in the lens holder by sliding the lens lock handle A into the “locked” position (left position for table mounted
projector).
6. Check if the lens is really secured by trying to pull the lens out of the lens holder.
R59770021 CLM R10+ 11/10/2010 171