Barco CLM R10+ - Manual (Page 174)

16. Servicing
A
B
Image 16-1
Filter top replacement
C AUTION : Never install a used HEPA filter. Always install a new HEPA filter.
C AUTION : Never use the projector with a removed cover. Always reinstall the removed cover.
16.2 Replacement of the dust filters on the front side
Necessary parts
Two new HEPA dust filters.
How to replace the filters on the front side of the projector
1. Switch off the projector and unplug the power cord from the wall outlet.
2. Remove the front cover, see "Removal of the front cover", page 181.
3. Remove the HEPA filter on the front side by pulling the spring clamp (A) on the upper side away from the filter and then pivot the
filter a little ( B) and take it out (C). (image 16-2)
4. Insert a new HEPA filter by pulling the spring clamp away and insert the filter into its position. Release the spring clamp.
5. Reinstall the front cover of the projector, see "Installation of the front cover", page 187.
170 R59770021 CLM R10+ 11/10/2010