Rockwell Automation 8520 9/Series Hardware TAB 5 - Manual (Page 32)

Location of TB5
on Wiring Board
P1
+
–
WATCHDOG
XILINX
TB4
J5
TB2 TB3
TB5
SHLD GND TPIN +5V
Section 5A
9/440 Resolver–based CNC/Drive System
5A-30
Figure 5A.18
Wiring Board Detail
Series A/B Wiring Board
Drive Interface
P1
+
WATCHDOG
XILINX
TB4
J5
TB5
J14
TB2
RET
ANLGOUT1
SHLD
RET
ANLGOUT2
SHLD
TB3
SHLD GND TPIN +5V
RIO2 SHLD RIO1
Battery Backup
Connection
Remote I/O
Plug
Analog Out 1
(spindle 1) Analog Out 2
(spindle 2)
Touch Probe Connection
F2
Spare
Fuse
F1
Fuse
[ALL FUSES]
[3A/125V]
–
–
F1
Fuse
[ALL FUSES]
[3A/125V]
J14
TB5
SHLD GND TPIN +5V
TB2
RET
ANLGOUT1
SHLD
RET
ANLGOUT2
SHLD
TB3
RIO2 SHLD RIO1
WATCHDOG
XILINX
F2
Spare
Fuse
Series C Wiring Board
Battery Backup
Connection
P1
+
Remote I/O
Plug
Analog Out 1
(spindle 1) Analog Out 2
(spindle 2)
TB4
The 9/440 resolver–based system module touch probe connection is made
to connector TB5 on the wiring board. Table 5A.A shows the location of
this connector and lists its terminal assignments.
Table 5A.A
TB5 Connector, 4 Plug-type Terminal Block Connections
Terminal Description Signal Destination
+5V Probe Power Touch Probe
TP IN Probe Fired Signal 1 Servo Position Latch
GND Touch Probe Common Touch Probe
SHLD Probe Shield connect at module only
1 The True level (voltage transition the probe fires) is either “HIGH” or “LOW” as
defined by the AMP parameter PROBE TRANSITION. Refer to your AMP
reference manual for more information.
Important: The touch probe connector supports only +5V probing device
applications.
5A.4.1
Wiring a Touch Probe to the
9/440