Rockwell Automation 8520 9/Series Hardware TAB 5 - Manual (Page 49)

Section 5A
9/440 Resolver–based CNC/Drive System
5A-47
Figure 5A.34
Connecting On/Off Power Control Assembly and 24V Power Supply
(22 kW Series C)
ON SW
COMMON
OFF SW
AC IN
AUX AC
AC POWER
FUSE
8A/250V
ALLEN–BRADLEY
Customer supplied
24V Power Supply
Output 24 V ac or
24 V dc non-polarized
ON
COM
OFF
E–Stop
COM
RESET
MTB Panel
Incoming Power
85–265 V ac
9/440 Resolver–based Power Strip
PE
ON/OFF
Control Assembly
BT02
Monochrome or Color
operator panel power
supply
To local cabinet
ground bus
High Low
Noise suppressor
199-ISMAxx
On Off Relay
Bulletin 100
A30–Nxx 15 AMP
Customer Supplied
Fuses
C
C1
L1
L2
L1
L2
PE
Optional Customer Circuit
Three–phase power to the 9/440 resolver–based control must be
324-528 V ac, 50/60 Hz. The drive power is used to supply the drive
portion of the 9/440 resolver–based control the voltages necessary to
power the axis modules and the servo motors.
All power connectors on the 9/440 Resolver–based power strip accept
AWG 12 gauge solid wire. Refer to local codes for required wire type and
gauge.
5A.5.2
Drive Power Three–phase