Video monitor connector – Rockwell Automation 8520 9/Series Hardware TAB 5 User Manual
Page 82
8
1
15
9
11257-I
Section 5B
9/440HR CNC/Drive System
5B-8
The E-Stop string is a 12V dc string protected by a .25 AMP 115 V fuse
located on the 9/440HR CNC processor board. You must remove the CNC
assembly from the system module to replace this fuse (see page
15B-58
for details).
CNC Processor Board
Front of
System Module
E-Stop
Connector
TB1
1/4 AMP E-Stop String Fuse
1/4 AMP fuse (spare)
Video Monitor Connector
The video monitor connector is used to interface the video monitor with
the control. Figure 5B.3 shows this connector and lists the pin
assignments.
Figure 5B.3
Video Monitor Connector-J8 (has pin sockets) and Pin Assignments
Pin No.
Signal Name
Pin No.
Signal Name
1
GND (SHIELD)
9
RED (L)
2
RED (H)
10
GREEN (L)
3
GREEN (H)
11
BLUE (L)
4
BLUE (H)
12
NC
5
NC
13
CLOCK (L)
6
CLOCK (H)
14
H-SYNC (L)
7
H-SYNC (H)
15
V-SYNC (L)
8
V-SYNC (H)