Rockwell Automation 8520 9/Series Hardware TAB 5 - Manual (Page 94)

Section 5B
9/440HR CNC/Drive System
5B-20
!
ATTENTION: To avoid damage to your motor, monitor
the thermal switch for overheat conditions.
14.
If you have: then:
more axis modules to wire move to the next axis module
and move to main step 2.
wired all of your axis
modules refer to your 1394 system
documentation.
!
ATTENTION: You cannot mount an auxiliary feedback
device to the rear of a 1326AB motor. By removing the
back cover of the motor, you will void the motor warranty
and possibly permanently disable it.
!
ATTENTION: Only auxiliary feedback devices are
replaceable. HIPERFACE devices are permanently
mounted by the factory and should not be removed. By
removing it, you will void the warranty and possibly
permanently disable it.