Rockwell Automation 8520 9/Series Hardware TAB 5 - Manual (Page 43)

Section 5A
9/440 Resolver–based CNC/Drive System
5A-41
Figure 5A.28
On/Off Control Assembly
ON SW
COMMON
OFF SW
AC IN
AUX AC
AC POWER
FUSE
8A/250V
ALLEN–BRADLEY
Incoming AC Power
85–265 Volts AC
To MTB panel
ON/OFF switch
Switched AC Out
85–265 Volts AC 8 amp max
PE
L1
L1
L2
L2
Logic power should be wired so that if the 24 V is not available to the
system module, it will open the drive contactors and disable 3 phase drive
power (see Figure 5A.39).