Rockwell Automation GV3000/SE AC Drive ControlNet Network Communication Board, M/N 2CN3000 - Manual (Page 26)

2-14 GV3000/SE AC Drive ControlNet Network Communication Option Board
Step 4. Install the ControlNet Option Board in the Keypad Bracket
Refer to figure 2.6 for component locations.
Step 4.1 Remove the ControlNet option board from its anti-static wrapper.
Step 4.2 Align the key on the connector of the ControlNet option board ribbon cable
with the key on the Regulator board connector. Press the ribbon cable
connector in until it locks into position.
Step 4.3 Route the other ribbon cable out of the side of the keypad bracket.
Step 4.4 Align the ControlNet option board on the four mounting tabs on the keypad
bracket. Make sure that the ribbon cable is not pinched between the keypad
bracket and the ControlNet option board.
Step 4.5 Fasten the right side of the ControlNet option board to the keypad bracket.
Use the two metal M3 screws and lock washers for grounding.
Important: You must use the lock washers to properly ground the option board.
Improper grounding of the option board can result in erratic operation of
the drive.
Step 4.6 Fasten the left side of the ControlNet option board to the keypad bracket
using the two plastic rivets.
Figure 2.6 – 1 to 20 HP @ 230 VAC GV3000/SE Drive
Keypad Bracket
Regulator Board
Terminal Strip
Power Terminal
Strip