Figure 5.4 - module properties: name selection – Rockwell Automation GV3000/SE AC Drive ControlNet Network Communication Board, M/N 2CN3000 User Manual
Page 75
Advertising
Configuring ControlLogix Applications
5-3
Step 3.
Enter a Name, Slot number, and Revision number (figure 5.4). Click Next>.
Step 4.
This step is used to define controller-to-module behavior (figure 5.5). Inhibit Module
inhibits/un-inhibits the connection to the module. The Major Fault check-box selects
if a failure on the connection of this module causes a major fault on the controller if
the connection for the module fails. Click Next>.
Figure 5.4 – Module Properties: Name Selection
Figure 5.5 – Module Properties: Controller-to-Module Behavior Screen
Advertising