Rockwell Automation GV3000/SE AC Drive ControlNet Network Communication Board, M/N 2CN3000 - Manual (Page 73)

Configuring ControlLogix Applications 5-1
C
HAPTER
5
Configuring ControlLogix Applications
Chapter 5 provides information and examples that explain how to use I/O Messaging
to control, configure, and monitor scheduled and unscheduled data on a GV3000
drive using a ControlNet scanner module.
Configuring a ControlLogix CNB scanner, and the network, is mainly done using RSLogix 5000
software (figure 5.1). RSNetWorx is still required, but only at the end of the configuration
process. Start the RSLogix 5000 software to begin the configuration process
.
!
ATTENTION: The examples in this publication are intended solely for
purpose of example. There are many variables and requirements with any
application. Rockwell Automation does not assume responsibility or liability (to
include intellectual property liability) for actual use of the examples shown in this
publication. Failure to observe this precaution could result in bodily injury or
damage to equipment.
Figure 5.1 – RSLogix 5000: I/O Configuration Selection