Metrohm 844 UV/VIS Compact IC - Manual (Page 34)

Table of contents
64
66 65
6.2744.070 PEEK compression fitting (short). The connection pieces
are mounted on the capillaries as follows:
PEEK capillaries that are to be provided with new connection pieces
must have a perfectly flat cut surface. This is best achieved by using
the 6.2621.080 Capillary cutter available as an option.
1 Mounting the compression fitting
• At the end of capillary Fehler! Verweisquelle konnte nicht
gefunden werden. that is to be attached push either a
compression fitting Fehler! Verweisquelle konnte nicht
gefunden werden. (6.2744.010) or compression fitting Fehler!
Verweisquelle konnte nicht gefunden werden. (6.2744.070)
over the capillary as shown in Fehler! Verweisquelle konnte
nicht gefunden werden..
2 Lead the capillary into the connection
• Push the capillary end into the corresponding connection
until it reaches the stop (in order to avoid dead volume).
3 Tighten up compression fitting
• Tighten up compression fitting Fehler! Verweisquelle konnte
nicht gefunden werden. or Fehler! Verweisquelle konnte nicht
gefunden werden. by hand (do not use any tools).
Figure 11: Connectors for PEEK capillaries
2.3.4 Connecting Steel capillaries
With the versions 2.844.0030 and 2.844.0130, the connections from
the high-pressure pump to the detector consist of 6.2620.020 Steel
capillaries (i.d. = 0.25 mm, e.d. = 1 /
16
" , length = 3 m), which are
connected with the steel connectors 6.2620.010 Ferrule and
6.2620.000 Pressure screw available as an option. The connection
pieces are mounted on the capillaries as follows:
Steel capillaries fitted with new connectors must have a perfectly flat
cut surface. This is best achieved by using the 6.2621.040 Capillary
tubing cutter available as an option.
64 Compression fitting
(6.2744.010)
65 Compression fitting
(6.2744.070)
66 Capillary 6.1831.XXX PEEK
capillary