Sindoh M403 - Manual (Page 119)

3-
37
Scanner, Printer and Fax
3
8. Basic Fax
Default Setting Change
1
Press the 【FAX】 button to the left of the LCD. Then [Std Enter No.] appears on the LCD.
2
To change the transmission mode, press the 【◀】 or 【▶】 button to go to [Tx Mode], and then
press the 【OK】 button. Here, Memory Tx, Broadcast Tx, Delay Tx and Polling Tx can be
selected. For more information, see the advanced fax function.
3
To change resolution, press the 【◀】 or 【▶】 button to go to [Resolution], and then press the
【OK】 button.
- Press the 【◀】 or 【▶】 button to select desired resolution, and then press the 【OK】 button.
4
To change the image type, press the 【◀】 or 【▶】 button to go to [Image Type], and then press
the 【OK】 button.
- Press the 【◀】 or 【▶】 button to select the desired image type, and then press the 【OK】
button.
Basic Operation
1
Place the document on the flatbed or ADF.
For more information, see 「Original Placing」 (P. 1-24) . Be sure to check if there is any
document in the ADF before placing the document on the flatbed.
2
Press the 【FAX】 button on the control panel to switch to the fax mode.
3
Select options if necessary.
Basic Fax (P. 3-37)
Advanced Fax (P. 3-40)
4
Enter the receiver’s fax number.
Number Pad (for direct input)
- Use the number pad to enter the fax number, and then press the 【 】 button.
- You can enter up to 40 digits.
- If a wrong number is entered, press the 【◀】 button to remove the number one by one.
Press the 【 】 button to delete all numbers.