Sindoh M403 - Manual (Page 166)

Settings of Each Function
4-
38
IP Address Setting
First, you have to set the IP address for network print and control. The DHCP server automatically
can allocate or fix the IP. Also, the IP address can be manually set.
Note
- Use the “SINDOH MFP Network Configuration” program to set the IPv6 address.
Using the control panel
1
When the device is ready, press the 【MENU】 button.
2
Press the 【◀】 or 【▶】 button until settings appear, and then press the 【OK】 button.
3
Press the 【◀】 or 【▶】 button to go to [Network Settings] -> [Wireless Network] -> [Wireless
AP Connection], and then press the 【OK】 button.
4
① IP Automatic Setting: Select automatic settings, and then press the 【OK】 button.
② IP Manual Setting: Select manual settings to type in the IP address, netmask and gateway,
and then press the 【OK】 button.
To set the IP address manually, see 「IP Manual Setting」 (P. 4-33) .
Note
- Use the “SINDOH MFP Network Configuration” program to set the IPv6 address.
Network Setting Program
1
Connect the USB cable, and turn on the device. At this point, the printer must not be
connected to the device via the USB cable.
2
Run the network setting program,“SINDOH Network Printer Setup”.
3
In the left window, go to [TCP/IP -> Wireless].
4
For IPv4, select TCP/IPv4; for IPv6, select TCP/IPv6.
5
① IP Automatic Setting (DHCP): Select [Use Static IP], and then press the 【OK】 button.
② IP Manual Setting: Select [Use DHCP IP] to enter network settings, and then press the 【OK】
button.