Sindoh M403 - Manual (Page 164)

Settings of Each Function
4-
36
5
① If there is no security settings, wireless network setting is complete.
② If the wireless AP has security settings, the wireless network security window appears.
WEP
Enter the WEP security key for authentication. If a connection is successfully made, wireless
network setting is complete.
Note
- For WEP, the 64-bit or 128-bit WEP encryption key is used.
WPA/WPA2
Enter the WPA key. If a connection is successfully made, wireless network setting is complete.
Note
- Just as the WEP, the WPA uses TKIP (Temporal Key Integrity Protocol) and AES(Advanced
Encryption Standard) for data encryption.
Enterprise WPA/Enterprise WPA2 (Wireless IEEE802.1x&EAP)
In case of enterprise WPA/enterprise WPA2, for user authentication, you have to enter the user ID
and password.
See the Wireless Security Password Entering and follow the LCD message to enter the user ID and
password. If a connection is successfully made, wireless network setting is complete.
Wireless Security Password Entering
Follow below steps to enter the password to access the wireless AP.
① When the password window appears, enter the password to access the wireless AP.
There are four character groups for your convenience: number (0 ~ 9), lower case (a~z),
upper case (A ~ Z), and symbol (@, #, %).
② Press the 【 】 button to switch to the character group. The group appears in order of, number
-> lower case -> upper case -> symbol -> “ ”.
③ Press number buttons or 【◀】 or 【▶】 buttons until the desired character or number appears.
Every time the number key is pressed, the character appears in order of, lower case ->
number -> upper case.
Press the 【◀】 or 【▶】 button to show characters in all character groups one by one.
If the desired number or character appears, press the 【OK】 button.