Sindoh M403 - Manual (Page 62)

Preparation for Using the Device
1-
34
15. MFP Setting Check
Switch On
1
Connect the end of the power cord to the port on the back of the device and plug the power
cord to the properly grounded wall outlet.
2
Switch on the device.
When initial warming-up is complete, the [Ready] message appears to indicate that the device
is ready to receive data.
If the message other than [Ready] appears, see P. 5-19 「Understanding of Messages」
3
Check your PC and see if other equipments are on.
4
Move to the next step.
System Report Printing
Print the system report to see initial settings and check if options are properly installed.
1
Check if the device is on.
2
Press the 【MENU】 button.
3
Press the 【◀】 or 【▶】 button until [Reports] appears.
Then, press the 【OK】 button.
4
Press the 【◀】 or 【▶】 button until “System Report” appears.
Then, press the 【OK】 button.
5
Press the 【◀】 or 【▶】 button until “System Report” appears.
Then, press the 【OK】 button.
6
Check the tray and paper type.