Sindoh M403 - Manual (Page 63)

1-
35
Preparation for Using the Device
1
Network Report Print
Print the Network Report to check network settings.
See network settings such as IP in the network report to change network settings.
1
Check if the device is on.
2
Press the 【MENU】 button.
3
Press the 【◀】 or 【▶】 button until [Report] appears.
Press the 【OK】 button.
4
Press the 【◀】 or 【▶】 button until [Network Report] appears.
Press the 【OK】 button.
Note
- To print from the network, enter the correct IP to the port field in the device’s deriver.
- The netmask should match the gateway.
- If the IP address is DHCP, no additional settings are required.
- If DHCP is selected, the IP address can be changed according to network environments.
If the device is not connected to the network, check the allocated IP address. If the IP
address keeps changing, contact your network administrator.