Sound Devices 788T - Manual (Page 142)

celeration” here refers the speed at which the value changes relative to the speed at which the Rotary
Encoder is rotated.
• Classic : The acceleration algorithm is the same as past fi rmware versions.
• Fixed (Max) : Each click of the Rotary Encoder will adjust the value at the maximum incremen-
tal amount.
• 2-Speed (Up to max) : 2 different adjustment rates that correspond to increasing rotation
speeds.
• 3-Speed (Up to max) : 3 different adjustment rates that correspond to increasing rotation
speeds.
Encoder Acceleration is confi gured in Setup Menu option CL-9 ENCODER ACCELERATION.
CL-9 Mode Basics
The CL-9 Mode Buttons allow the user to quickly access a variety of parameters, including the EQ
and Pan settings. There are six Factory Modes and four assignable User Modes on the CL-9. The ac-
tive mode determines the functionality of the Rotary Encoders and CL-9 Ring LEDs.
Trim (default) mode is the main operational mode. When in Trim mode none of the Mode LEDs are
illuminated. Trim mode is always the fi rst active mode upon power up of the 788T/ CL-9 system or
after connecting the CL-9 to the 788T.
To navigate to another Factory Mode, press one of the Mode Buttons. To access a User Mode, press
and release the Shift Button, the Shift LED fl ashes blue, then press the assigned Mode Button. To
return to Trim mode, press the currently active mode’s button again. When a Factory Mode is ac-
tive, the respective Mode LED fl ashes green. When a User Mode is active, the respective Mode LED
fl ashes blue. The specifi c setting for the active mode is displayed on the 788T Main LCD display.
In all modes except Output Mode, the CL-9 Ring LEDs indicate pre-fade signal level (PFL) in vari-
ous colors and intensities to represent the state of each channel.
See Output Mode for details. Green
= signal activity, Yellow = pre- and post-fade limiter activity, Red = signal overload (clipping). The
LEDs illuminate solid red when an input is muted and solid yellow when soloed in the headphone
monitor. If no valid sync source is detected, the CL-9 Ring LED rings fl ashes yellow.
In all modes except Output Mode, press an input’s rotary encoder to solo (PFL) the input. See Output
Mode for details. Mode-specifi c functions are toggled by pressing and holding the Rotary Encoders for
one second or longer. Modes that have variable settings are adjusted by turning the Rotary Encoders.
Factory Modes
The six Factory Modes are:
• Trim (Default)
• EQ Frequency
• EQ Gain • EQ Q-Factor
• Pan
• Output
To access a mode, press a Mode Button. Press the selected Mode Button again to return to Trim
mode. To immediately access another mode, press any one of the Mode Buttons. When a mode is
active, the respective Mode LED fl ashes green. The following chart illustrates the behavior of each of
the factory modes.
Mode Ring LED 788T LCD
Display
Encoder
Turn
Encoder
Press
Encoder Press
and Hold
Trim (default) Metering (PFL + Post-EQ)
Input Solo (yellow)
Input Mute (red) Trim Levels in dB. Trim Level adjust Toggles Input Solo N/A
788T/788T-SSD User Guide and Technical Information
134
v. 3.02 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
Hardw
are Controllers
10