Sound Devices 788T - Manual (Page 35)

When the CL-9 is attached to the 788T, the trim and fader levels are adjusted only from the CL-9. The
788T Front Panel Gain Controls simply activating/deactivating inputs.
When the CL-8 is attached to the 788T and the Setup Menu option INPUT: FRONT PANEL CONTROLS
is set to Trim Controls or Fader Controls, the behavior of the front panel Input Gain Control adjusts
trim levels and the CL-8 rotary potentiometer controls the Input Fader level. When Setup Menu op-
tion INPUT: FRONT PANEL CONTROLS is set to Input Enables Only, the behavior of the front panel
Input Gain Control simply activates/deactivates the input, trim levels are adjusted in the Input Set-
tings Window using the Rotary Encoder, and the CL-8 rotary potentiometer controls the Input Fader
level. When the CL-8 is attached, the Fader Controls option has no effect. The front panel controls
continue to act as trims and the CL-8 faders act as input fader controls.
When the CL-2 is attached and assigned to an input, the input’s fader level will be controlled by the
CL-2 only.
Input Settings Window
From the Input Settings Window, view and/or change the following settings:
• Input Type
• Phantom Power
• High-Pass Filter
• Input Gain (Trim and Fader)
• Input Limiter • Input Polarity
• Input Mute
• Input Routing
• Mix Assist
To enter the Input Settings Window, press the desired input’s Front Panel Input Selector Switch. The
Input Settings Window will latch on, this allows for one handed operation of the 788T. If momentary
action is desired, press and hold the Input Selector Switch for one second or more. To exit the Input
Settings Window press the selected Input Selector Switch again or select another Input.
While in the Input Settings Window the selected input is displayed in the center of the screen. The
selected input will be soloed in the headphone monitor, although this can be disabled in the Setup
Menu option INPUT: PFL FUNCTION.
If the Input Selector/Solo Switch is held for 5 or more seconds “Hold” will appear on the screen
and the soloed input will remain in the headphone monitor until either another headphone moni-
tor mode has been selected with the Rotary Switch or with the Input Selector/Solo Switch. Once the
Input Selector Switch is pressed again, the 788T will return to the previously displayed screen.
If the selected input is stereo linked, both of the inputs will be soloed in the headphone monitor.
Inputs and Outputs
3
788T/788T-SSD User Guide and Technical Information
27