Sound Devices 788T - Manual (Page 147)

are reduced to 15 mS with sampling rates at or above 88.2 kHz and 7.5 mS with sampling rates at
or above 96.096 kHz. The Input Delay values are displayed on the 788T Main LCD Display while in
Input Delay Mode.
Input Polarity Mode (User)
In Input Polarity Mode, press and hold the input’s Rotary Encoder for one second or longer to toggle
the polarity of an input between normal and reversed. The Input Polarity status is displayed on the
788T Main LCD Display while in Input Polarity Mode.
None (User)
When a User Mode is set to none, the Shift function does not apply to the assigned button. Pressing
shift, then pressing a User Button set to none, loads that Button’s Factory Mode.
CL-9 Input-to-Track Routing
Mode Ring LED 788T LCD
Display
Encoder
Turn
Encoder Press Encoder Press
and Hold
Track Routing Input Routed Pre-Fade
(green)
Input Routed Post-Fade
(red) N/A N/A Toggles Routing of
Input to Track Toggles all inputs
routed to that track as
Pre- or Post-Fade
Input Routing and Track Enabling are performed directly from the CL-9 interface without having to
enter any of the 788T menus. The A-H, and L,R Track Buttons are located on the top row of the CL-9.
The Aux 1 and 2 Track (X1, X2) Buttons are located immediately below the Left and Right Master
Gain Level Controls.
Press and release a Track button to enable the respective track. The Track LEDs illuminate blue when
a track is ready to record (Armed). By default, the Track LED fl ashes blue to indicate that the track is
record enabled but no active input is routed to it and therefore will not be recorded. The Track LED
remains off when the Track is disabled.
The fl ashing behavior of the Track LED can be disabled with the Setup Menu option Meter: Track Arm
LEDs.
Hardw
are Controllers
10
788T/788T-SSD User Guide and Technical Information
139