Se tup and shor tcut r eference 11, Setup name description options factory default – Sound Devices 788T User Manual
Page 159
# Setup
Name
Description
Options
Factory
Default
23.
Input: Limiter Threshold
Selects the threshold at which the in-
put limiters will become active across
all inputs where the input limiter has
been enabled in the Input Settings
Window.
-12 to -2 dBFS attenuated by .1 dB incre-
ments
-4 dBFS
24.
Input: Limiter Recovery
Adjusts the recovery time of the
limiter in milliseconds.
50 to 2000 msec adjustable in 10 msec incre-
ments
200 msec
25.
Input: Limiter Knee
This selects the response charac-
teristic of the limiters as the Limiter
threshold is reached.
• Hard-Knee
• Soft-Knee
• Hard-Knee with 20:1 slope
• Soft-Knee with 20:1 slope
Hard-Knee with
20:1 slope
26.
Input: Low Cut Slope
Selects the amount of slope of the
high-pass (low cut) filter. Frequency
roll off point is selectable in the Input
Settings Window from 40 to 320 Hz in
10 Hz increments.
• 6 dB/oct
• 12 dB/oct
12 dB/oct
27.
MixAssist: Mode
Turns Mix Assist on or off. When On
(LR Tracks Only) option is selected L
and R tracks are the only tracks Mix
Assisted. When On (All Tracks follow
LR) is selected all post fade tracks
will be affected by Mix Assist.
• Off
• On (LR Tracks Only)
• On (All Tracks follow LR)
Off
28.
Input 1: Delay
Sets a digital delay for each input.
Can be used to compensate for delay
in various digital wireless microphone
units or digital processors.
0–30 milliseconds @ 48.048 kHz and below
0–15 milliseconds @ 88.2 kHz and above
0-7.5 milliseconds @ 176.4 kHz and above
in 0.1 mS increments
0 mS
29.
Input 2: Delay
30.
Input 3: Delay
31.
Input 4: Delay
32.
Input 5: Delay
33.
Input 6: Delay
34.
Input 7: Delay
35.
Input 8: Delay
36.
Input: PFL Function
Sets the headphone monitor behavior
when an input is selected using the
Input Selector Switch. When enabled,
the input will be soloed in the head-
phone monitor. When disabled, the
Input Settings Window will appear but
the headphone monitor will remain
unaffected.
• Enable PFL
• Disable PFL
• Disable PFL with CL-8 Connected
Enable PFL
Se
tup and Shor
tcut R
eference
11
788T/788T-SSD User Guide and Technical Information
151