Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 29)

2. The scale will clear the last M+ addition.
If the scale beeps 4 times, there is no M+ addition to erase.
Automatic M+ Accumulation Mode
‰ M+ Accumulation can also be done automatically each time you count a different
batch, As soon as you have a stable count, it will be added to the M+ memory and
the scale will beep
‘. The weight display will have to return to near zero before
another count can be added.
Automatic M+ accumulation is set by F-Function
f-03-01 at “1”.
Only positive counts can be added. If F-Function
f-03-02 is set at “1” (to accept
negative count data), it will be ignored.
Once there is an automatic M+ accumulation, the display must return to less than
+5d before another count can be accumulated.
6-2. Viewing the M+ Total
1. Press the TOTAL key.
The count display will show the
total count and the
TOTAL
indicator will come ON.
The number of additions to the M+
memory is also shown.
2. Press the TOTAL key again.
The display will return to normal.
TOTAL
 TOTAL indicator
comes ON.
TOTAL
Count
Number of additions to M+ memory
STABL
      
. 8888 678 
SFV
  $ : ( , * + 7  N J 
123456718- 0.000
   6 $ $ 0 7 R W D O  1 
1234516711100 7
ZERO TOTAL M+
TARE
ENTERED SCALE
6-3. Clearing the M+ Total
1. Press and hold the C key, then press
the TOTAL key – release both.
2. The scale will clear the M+ memory, and the TOTAL indicator and the M+
indicator will go OFF.
TOTAL
C
+
‰ The RESET key does not clear the total data.
‰ The total data is held in memory, but if AC/Battery power to
scale is interrupted, the total data will be lost.
6-4. The M- Function
‰ The scale can subtract count data from M+ memory by using the key.
‰ Set the F-Function f-09-01="1" to use the key as M- key.