Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 52)

12-5. Command Mode
‰ In the command mode, the scale is controlled by commands that come from an
external device, computer etc.
Do not set
f-06/07/08-01="1" (stream mode) to use with the command mode. if
you don’t want to use command mode together with key mode or auto-print mode,
set
f-06/07/08-01="4" (command mode only).
‰ Use a D-sub 9 pin cable (straight type) to connect with a computer.
Option cable: AX-KO2466-200, D-sub 9 pin, 2m
Command List
Command Definition Notes
@ Start / stop continuous data transmission.
A Same as RESET key. Key command
D Set a known tare weight.
“D,1.23C
R
L
F
” sets the tare
weight as "1.23kg".
E
Store the unit weight in use, other values and
specified item code to ID memory. Refer to the data format.
Refer
f-01-05
F Recall a unit weight from ID memory.
“F123C
R
L
F
” recalls from
ID000123.
G Set a known unit weight.
“G,0.123C
R
L
F
” sets the unit
weight as "0.123g" (or "0.123 lb").
I Same as the REMOTE SCALE key.
J Same as the TOTAL key.
Key command
K Same as the M+ key.
P Same as the STANDBY/OPERATE key.
Key command
Q Send data immediately.
S Send stable data after accepting command.
Data depends on
f-06
/
07
/
08-02
T Same as the TARE key. Key command
X Request a list of the F-Function parameters.
Y Request a list of the ID memory contents.
The last data terminates with
<EOT> (04H)
Z Same as the ZERO key. Key command
ON Turn the display ON.
OFF Turn the display OFF.
?ID Send the ID number and item code in use.
?QT Send the pcs (count) data.
?WT Send the weight data.
?UW Send the unit weight in use.
?AQ Send the total (accumulated) M+ memory count
d t
?AN Send the number of additions to M+ memory.
?TR Send the tare weight in use.
?MR Send the specified ID memory contents.
Refer to the data format for the
reply.