Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 30)

This function is not to clear the last M+ addition, but to subtract count data instead
of addition. The number of additions is increased.
There is no automatic M- function.
7. COMPARATOR FUNCTION
‰ The scale contains a comparator function that checks the amount on the weighing
pan against set acceptable count or weight
levels. When the comparator function is
activated, “
+, ”, “ 2. ” or “ /2 ” is displayed.
‰ Before the comparator will work, upper and
lower limits must be set (refer to below). The
levels are set by count or weight. So, if you
are using weight for your comparator levels,
calculate the weight before starting the
procedure below.
‰ If OP-04 is installed, comparator relay output
is also available.
‰ The comparator responds as follows,
“ +, ” Upper limits < Count / Weight data
“ *2 ” Lower limits d Count / Weight data d Upper limits
“ /2 ” Count / Weight data < Lower limits
      
. 888- 100 
SFV
  $ $ : ( , * + 7  N J $ % ' ( + 2 . / 2 D D 
1213415678 11.100 578id-123456
  $  6 $ $ 0 8 8 :  J  % & ' ( ) * + , - . /
123451167 111.000

‘ Ñbeep, beep …Ò ‘
Upper limit 102 pcs
Lower limit 98 pcs
The beeper is set ON at
To Set the Comparator
‰ Start with the scale in standby mode, display OFF.
1. Press and hold the ZERO key, then press
the STANDBY/OPERATE key – release
both.
The count display will show “
f-00”
with “
00” blinking.
2. Press the 5 key to enter into the
F-Function
f-05-
X Comparator .
ZERO +
OPERAT
STANDBY
5
      
.f-05-01 
SFV
& R P S D U D W R U 
12345678C000045678 d 00000 0
      
.f-00 0 
SFV
6 H W  ) X Q F W L R Q  1 R  
12345678C000045678id-000000
   6 $ 0 8 8 :  J   & O H D U  , ' 
12345670.0000045678901234567
      
.f-05 -00 
SFV
& R P S D U D W R U 
12345678C000045678id-000000
   6 $ 0 8 8 :  J   & O H D U  , ' 
12345670.0000045678901234567
3. Press the ENTER key.