Rice Lake FC-i/Si Series, A&D Weighing - Manual (Page 49)

12-2. Data Output Mode
‰ The data output modes and parameters are set by F-Functions in f-06 /
07
/
08-X
as described in the F-Function parameters, section 9.
‰ To control the scale using commands from an external device, refer to “
12-5.
Command Mode”.
‰ Refer to “
12-5. Command Mode” about the output data format.
Data Out Mode (f-06/07/08-01)
‰ Key Mode (f-06/07/08-01="0")
When the weight display is stable, data is sent by pressing the PRINT key.
The count display will blink when the data has been sent.
‰ Stream Mode (f-06 /
07
/
08-01="1")
Data is sent continuously. The data-update rate is approximately 5 times per second for
f-06
/
07
/
08-03="2". For f-06
/
07
/
08-3="0" or "1", the interval between continuous data is
approximately 2 seconds.
‰ Auto-print Mode A (f-06 /
07
/
08-01="2")
Data is sent if the WEIGHT display is stable at +5d (weighing display division) and
above. The next transmission can not occur until after the weight display falls below
+5d.
‰ Auto-print Mode B (f-06 /
07
/
08-01="3")
Data is sent if the WEIGHT display is stable at ±5d (weighing display division) and
above/below. The next transmission can not occur until after the weight display falls
between –5d and +5d.
To use with the UFC format.
Refer to "
12-7. Using UFC (Universal Flex Coms) Function"
Data to be Sent (f-06/07/08-02)
Select which data is o be sent by keying in a 0 or 1 for the data: Date / time, ID
Number, PCS (count), weight or unit weight.
Example: Key in 0 1 1 0 0 to display
01100, this setting would send only the
ID number and the count.
Unit weight
Weight
PCS (count)
ID
Date / time
      
.f-06-02 
SFV
& R P S D U D W R U 
12345678C000045678id-0 01100
   6 $ 0 8 8 :  J   & O H D U  , ' 
12345670.0000045678901234567
‘
0’ not to send data
‘
1’ to send data