4. standby and operating mode, 5. 1-6. simple operation mode, Kg or lb weighing units – Rice Lake FC-i/Si Series, A&D Weighing User Manual

Page 9

Advertising

1-4. Standby and Operating Mode

The scale has two principal modes: Standby mode and operating mode.

Standby mode: When the scale has power supplied to it, either by the AC Adapter or

the battery pack, and the display shows a decimal point, the scale is in
the standby mode. In day-to-day operation, standby mode is normal
when the scale is not in use. This keeps the weighing mechanism
warmed up.

Operating mode: If the display is turned on from standby mode, then the scale is in

operating mode.

If the scale is not going to be used for a long period of time, then it may be appropriate
to disconnect the main power.

Use the STANDBY/OPERATE key

to turn the display on or off.
When the scale is in
Standby mode, a
period appears in the
weight display as an
indicator.

1-5.

1-6.

Simple Operation Mode

If desired, the scale can be set in a simple operation mode. In this mode, only front
panel keys that would be used in “

3-3. Unit Weight By Samples” counting operations

are active. All others will not operate. The following keys are active in the simple
operation mode:

Keys that will operate in simple operation mode:

kg or lb Weighing Units

The scale can weigh and register the unit weight in pounds or kilograms (it comes set
to pounds "lb"). When you switch between the weighing units, the display will show the
current weighing unit, and any weight amounts being used are also converted.

To change the weighing units between

pounds and kilograms, refer to F-Function
f-00-01. Set at “0” for kg; or at “1” for lb.

STABL

888888

SFV

: ( , * + 7 O E

1123456789

0.000

$ 8

8 : O E

12314567

0.00000

ZERO

TOTAL

M+

TARE

ENTERED

SCALE

ACAI

SAMPLE

TOO LIGHT

OPERAT

STANDBY

ZERO

TARE

SAMPLE

ENTER

RESET

Æ 9

USA Version ONLY