Programmable-unit, Operation – Rice Lake FX-i WP Series, A&D Weighing User Manual
Page 56
54
12. PROGRAMMABLE-UNIT
This is a programmable unit conversion function. It multiplies the weight data in grams by an arbitrary
coefficient set in the function table and displays the result.
The coefficient must be within the range between the minimum and maximum shown below. If the
coefficient set is beyond the range, an error is displayed and the balance returns to the coefficient setting
mode, prompting to enter an appropriate value. A coefficient of 1 was set at the factory.
Model
Minimum coefficient
Maximum coefficient
FZ-120i WP FZ-200i WP FZ-300i WP
FX-120i WP FX-200i WP FX-300i WP
1000
FZ-1200i WP FZ-2000i WP FZ-3000i WP
FX-1200i WP FX-2000i WP FX-3000i WP
0.000001
100
Operation
1 Press and hold the
SAMPLE
key until ba5fnc of the function table is displayed.
2 Press
the
SAMPLE
key several times to display mlt .
3 Press
the
key. The balance enters the mode to confirm or set the coefficient.
Confirming the coefficient
4 The current coefficient is displayed with the first digit blinking.
When it is not to be changed, press the
CAL
key and proceed to step 6.
When it is to be changed, press the
RE-ZERO
key and proceed to step 5.
Setting the coefficient
5 Set the coefficient using the following keys.
SAMPLE
key To select a digit to change the value.
The selected digit blinks.
RE-ZERO
key To change the value.
MODE
key
To change the decimal point position.
Each time the switch is pressed, the decimal
point position changes as follows:
0.000001
00.00001 ... 000000.1
0000001
key
To store the new setting, display end and go to step 6.
CAL
key
To cancel the new setting and go to step 6.
Quitting the operation
6 The
balance
displays
Unit . Press the
CAL
key to exit the
programmable-unit function and return to the weighing mode.
Using the function
Press
the
MODE
key to select the programmable-unit (no display on the unit section). Perform
weighing as described in “5-1 Basic Operation (Gram Mode)”. After weighing, the balance displays
the result (weight data in grams X coefficient).