Rice Lake IQ 700 Configurable Weight Indicator - Manual (Page 31)

Options Configuration 27
4.3 Option 3 – Time and Date
The main purpose for time and date is to allow the operator to quickly change the time when the time changes
between standard and daylight savings time.
The time and date clock is attached to the battery-backed memory (U4) and will continue running when the
indicator is off.)
Table 4-5. Option 3 Configuration Selections
NOTES:
• Prior to setting the time and date, select the current time (dLs–daylight savings or Std–standard). This
feature selection allows the operator to increment or decrement the time by one hour when clocks are
changed from dLs or Std without having to re-program the entire time.
• Time and date can be directly accessed in normal running mode by pressing both the 0 and 3 keys for a few
seconds. This allows the time or date to be changed without using the option switches. To exit,you must be
at 3.1 to 3.5 and then press the
0 key. This sequence does not work with 3.6 or 3.7.
Option 3 configuration parameters are graphically illustrated in Figure 4-9.
Figure 4-9. Option 3 Menu
Refer to Section 4.12.3 on page 45 for individual serial command option parameters for Option 3.
Prompt Display Interpretation Notes
Time and date option Time and date settings can be directly
accessed in normal running mode by
holding down both the
0 and 3 keys for
a few seconds. The operator can then
make changes without using option
switches. To exit, press the
0 key.
OP.3 oFF Off (time and date disabled)
OP.3 On On (time and date enabled)
3.1 Std
dLs Standard Time
Daylight Savings Time
3.2 12
24 Selects 12- or 24-hour time display
3.3 A
P AM (A) or PM (P) setting when 12-hour clock is selected
3.4 Un
Ab
on Selects the location of printed time and date data: under (Un),
above (Ab), or on the same line (On) as weight data.
3.5 LEt
nO Prints date in letters (LEt) or numbers (nO).
For example: Sept 1, 1999 vs. 09/01/99
3.6 tI Time. Use numeric keys to enter the time in hours, minutes and
seconds (HHMMSS), then press the
ENTER key (see Note
below)
The display for parameters 3.5 and 3.6
alternates between the parameter and
the current data value. This continues
until new data is entered using the
numeric keys. After entering new data,
press
ENTER again to alternate the
display.
3.7 dA Date. Use numeric keys to enter the date in month, day and
year format (MMDDYY), then press the
ENTER key (see Note
below)
XXXXXXX XXXXXXX XXXXXXX XXXXXXX OPTION 5 OPTION 4 OPTION 3 OPTION 2 CALIBR CONFIG OPTION 6 OPTION 7 OPTION 8 OPTION 10 SERIAL OPTION 1
TYPE
OFF ON
Off
TIME/DATE DLS HR A–PT
On
Std.
dLs
12
24
Am
Pm
POS TI DATE
Under
LEt
letter
hh.mm.ss mm/dd/yy
OPTION 9
Above
On
nO
number
OPTION 11