Rice Lake IQ 700 Configurable Weight Indicator - Manual (Page 68)

64 IQ 700 Installation Manual
8.1.5 Full Duplex Parameter Entry/Recall
One of the capabilities of the IQ 700, with the full duplex serial port 1 is the ability to enter or recall setpoints from
a computer or terminal. The following table illustrates full duplex setpoint parameter entry/recall.
Table 8-2. Full Duplex Setpoint Parameter Entry/Recall
The response data ( xxxxx ) is corrected for count-by round off and is six characters in length if there is no decimal
point and seven with the decimal point. Leading zeros are spare characters.
Invalid data requests or entries are responded to with an echo of the valid portion and an I indicating the invalid
portion.
8.2 Delay Demand Print
When file 7.17 is enabled, a demand print, from either the print key or the remote print (TB3-10), is delayed for up
to 25 seconds if the scale is in motion. If the scale comes out of motion before the 25-second timer times out, the IQ
700 will do a print of the data. If the scale remains in motion, the demand print is aborted.
8.3 Battery Option
The IQ 700 has an optional battery that can be installed. The indicator enclosure must be opened to connect the
battery to the CPU board. Use the following steps:
1. Disconnect AC power by uplugging the indicator.
2. Remove the screws that hold the front bezel to the enclosure body.
3. Place the indicator face down on an antistatic work mat, then lift the back of the indicator away from the front
bezel.
4. Set the enclosure aside.
5. Locate the battery plug in on the CPU board (J6) shown in the diagram below.
Figure 8-5. Battery Location
6. Plug other end into battery located on the enclosure backplate.
Setpoint Parameter
SE<n> (entry)
SR<n> (recall) 0 1 2 3 4 5 6
Mode A all SP1 SP2
Mode B all SP1 Pr1 SP2 Pr2
Mode C all SP1 dr1 SP2 dr2
Mode D all SP1 Pr1 dr1 SP2 Pr2 dr2
Mode E all SP1 Pr1 dr1 HI Lo
Mode F all SP1 HIGH
Mode G all SP1 LOW HIGH
J7 K1
S3
J5
J3
F1 J6
TB5
TB1
–EXC
–SEN
–SIG
+SIG
+SEN
+EXC
6
5
4
3
2
1
LOAD CELL CONNECTOR
1 2
U2
Q5
U18
GND LO HI
TO POWER SUPPLY
CPU Plug in
for Battery