Rice Lake IQ 700 Configurable Weight Indicator - Manual (Page 40)

36 IQ 700 Installation Manual
Table 4-15. Option 7 Configuration Parameters (continued)
NOTE: Selections 7.19 and 7.20 are available in EPROM (KDA1921-3).
To Create a File
To create a new file use the following steps:
1. Go to the desired file (7.1–7.16) using the TARE
key.
2. Set file to on using the lb/kg CONV key.
3. Step to the first file line (01) using 1 SETPOINT
key.
4. Using the numeric keyboard, enter the ASCII
character or parameter code using the tables in
Section 9.0 on page 63. NOTE: all codes are
three digit decimal numbers and leading zeros
need not be entered.
5. Go to the next line using the 1 SETPOINT key.
6. Repeat steps 4 and 5 until the file is complete.
End file with the code 999.
To Edit a File
Files may be edited in one of three ways:
• A new code can be added/modified
• Codes can be deleted from a file
• Codes can be inserted into a file
Add/Modify a Code
To add or modify an existing code:
1. Select the file position to be added or modified
using the 1 SETPOINT key to increase or the 2
SETPOINT key to decrease to the desired file
number.
2. Enter a new code using the numeric keys.
Delete a Code
To delete a code:
1. Select the file position to be deleted using the 1
SETPOINT key to increase or the 2 SETPOINT
key to decrease to the desired file number.
2. Press CE key.
Insert a Code
To insert a code:
1. Select the file position where the new code is to
be inserted using Setpoint keys as described
above.
2. Press ENT key (observe 000 code).
3. Enter the new code using numeric keys.
NOTE: Refer to the Parameter Control Chart in Section
9.0 , Table 9-2 for commands.
7.19
one
odd
evn
SPC
Transmit parity selection
Mark parity
Odd parity
Even parity
Space
7.20
oFF
on
Receive data parity
Disabled – parity observed when receiving data.
Enabled – parity is ignored when receiving data.
Option Prompt Display Interpretation