Rice Lake IQ 700 Configurable Weight Indicator - Manual (Page 61)

Setpoints 57
Table 7-1. Setpoint Configuration Modes
Mode G Over/Under checkweigh control
Provides High, Low, and Accept outputs except a direct entry is made for a target weight and high/
low settings become dependent.
Use the following steps to set Mode G setpoint values.
1. Press SETPOINT 1
2. Enter the desired target value; then press ENT .
3. Press SETPOINT 2
4. Enter the desired high tolerance (HI) value and press ENT .
5. Enter the desired low tolerance (L0) value and press ENT .
LOW
ACCEPT
HIGH
ZBD
Manual
Batching
Mode
The manual batching mode operates as follows:
1. Press the START key located in the lower left corner of the front panel. The setpoint LED is on.
2. Setpoint 1 is activated if enabled. If enabled, skip step D.
3. When the displayed weight reaches or exceeds the setpoint value, the setpoint is deactivated.
4. The unit enters a pause mode locking out zero, net/gross, and tare keys during run. During Pause, the
tare key is still functional.
5. Press the START key again and setpoint 2 is activated.
6. When the display weight reaches or exceeds the setpoint 2 value, the setpoint is deactivated.
7. Press START and the unit returns to normal operation with all keys active.
If the CE key is pressed at any time during the batching process, the setpoints are deactivated and the unit
returns to the normal operating mode.
Automatic
Batching
Mode
The automatic batching mode operates as follows:
1. Press the START key, and the setpoint LED light turns on.
2. The unit is switched to the net weighing mode.
3. An automatic auto tare operation takes place.
4. Setpoint 1 is activated.
5. When the displayed weight reaches or exceeds the setpoint value, the setpoint value is
deactivated.
6. The setpoint indicator LED turns off
7. Timer 1 phase begins. If timer 1 is turned off, the unit enters an indefinite pause mode and
the start key must be pressed to continue to setpoint 2. Otherwise the unit pauses for 1 to
10 seconds, depending on the timer 1 value.
8. Upon timeout (or pressing the START key), the unit will do a demand printout (1 or 3 lines
depending upon configuration).
9. An auto-tare operation takes place.
10. Setpoint 2 is activated until the displayed weight reaches or exceeds the setpoint value.
11. Timer 2 phase begins and the same conditions apply as in number 7.
12. Upon timeout, the unit does a demand printout.
13. The unit returns to normal operation in the gross mode.
If the CE key is pushed at any time during the batching process, the batch process is aborted, the
setpoints deactivated, and the unit returning to normal operating mode. During batch run mode,
front panel functions are disabled.
Mode Description Setpoint
MODE G
WIRE
PLACEMENT
TB3 - 5
TB3 - 4
TB3 - 3
TB3 - 2
100 90 80 70 60 50 40 30 20 10 0
WEIGHT
ZBD
LOW ACCEPT HIGH