Rice Lake Sartorius Midrics 1 and 2 Series - Operating Instructions - Manual (Page 49)

Operation
Basic Weighing Function
Weighing W
The basic weighing function is always
accessible and can be used alone or in
combination with application programs,
such as Counting, Checkweighing,
Weighing in Percent, etc.
Features
– Zero the scale (
– Store the weight on the platform
as tare by pressing )
Midrics 2 only:
– Use the numeric keys to enter a tare
weight (press ) to save)
– Tare container weight automatically
– Delete tare values by entering 0
(press ) to save)
– Press k to toggle the display between:
– Gross and net values, or
– Normal and 10-fold increased
resolution (displayed for max.
5 seconds)
Midrics 2 only:
– Individual ID codes for weight values
– Print weight values:
– Manually, by pressing p
– Automatically (see “Data Output
Functions")
– With GMP-compliant format
(see “Data Output Functions")
– Restore factory settings by selecting
the corresponding menu setting
Automatic Taring
The first weight on the scale that
exceeds the preset minimum load is
stored in the tare memory at stability.
The values for subsequent loads are
stored as weight values. The scale
returns to the initial state when the
load is less than 50% of the minimum
load.
Minimum Load
To tare container weights automati-
cally, set the minimum load in the
operating menu.
You can choose from 10 settings,
defined in scale intervals (digits),
ranging from:
1 digit (no minimum load)
to
1000 digits
The “digits" here refer to the scale
intervals in the connected weighing
platform. Example: If the scale interval
(d) is 1000 g and the minimum load
is set to 1000 digits (=1000 scale
intervals), a load of at least 1000 g
is required for autotaring.
Automatic Printing
The first weight value that exceeds
the minimum load is printed.
Device Parameters
Keys
The keypad can be blocked.
There are four settings to choose from:
– All keys unblocked
– All keys blocked except e and M
– Numeric keypad blocked
– One specified key blocked
(see the menu in the chapter entitled
“Configuration" for options)
Display
You can have the display backlighting
shut off automatically when not in use
Automatic Shutoff
You can have the display and control
unit shut off automatically.
Timer Mode
There are three timer settings for
the shutoff functions: two, four and
ten minutes.
Settings
See the chapter entitled
“Configuration."
49